Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Yea this is a nice site thank you. I wasn't sure of the terminology used for this. In some tutorials they call them image planes, others reference image and I guess blue prints Thank you I will find something to work on from this site.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off