a little bit of progress.
i did plan on finishing up today but didn't get round to that...
anyway, decided to redo the scythe/claw/blade thing because the topology of it wasn't working all that well.
if i were to use the reotopology tool i'd have to do both sides seperately since it was no longer in the center so i couldn't use symmetry.
this time i remembered to take a picture of the cool new shadow box for you guys
except after doing this i used GoZ and flattened out some part of it so i could use the planer brush to make it properly flat on both sides. and then at some point zb crashed and i lost everything.
well.. not entirely true. i still had it in maya, but i closed that without saving and then
i had lost everything
but here's the second attempt (forgot to snap shot a shadow box for this but the result is almost the same)
and from a lower angle
there is no longer a giant ball attached to this since i couldn't make a decent enough sphere and then i remembered that i should be able to merge subtools together so i'll grab a sphere and merge it with that
also, this is meant to be made of bone, so it shouldn't be entirely smooth
although, now that i think about it, i dont think bone would have such sharp corners as you see at the top... think i'll make the transition softer
that's a "Ch" pronounced as a "K"
Computer skills I should have:
Maya, XSI, Photoshop, AfterEffects, Motion, Illustrator, Flash, Swift3D