Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
When ever I move an isoparm or use any paint brushes, I get this red re draw issue. If I'm painting with a brush I can fill up the screen with these bloody red lines!!!!!
What could it be??
Yeah done that. I have changed all my settings on the card to see if it makes any difference but none at all. Doesn't matter what the card is set to...!
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off