im stuck again

Maya 2020 fundamentals - modelling the real world

Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.

Watch

# 1 19-01-2005 , 10:20 PM

Subscriber
Join Date: Jun 2004

Posts: 4

hi,

i need some assistance again in the mech tutorial in the part wher you make the section on the foot above the ball joint when i convert it to sub divisions it still angular while in your video the corners are more rounded it looks okay but i was wondering what i have done wron it looks fine untill almost identicall untill you convert it to sub divisions

thanks macca999

Quote

# 2 19-01-2005 , 10:57 PM

Registered User
Join Date: May 2002

Location: Niagara Falls, Canada

Posts: 5,310

Still sounds like you do not have you keep faces together option selected in you polygon tool options. If it keeps up post the file and I'll have a look when i get a free second.

I am enough of an artist to draw freely upon my imagination, knowledge is limited, imagination encircles the world. (Albert Einstein)

https://www.artstation.com/kurtb

Quote

Reply to this thread