Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Just discovered this one today by accident. If you marquee select, then hold alt/option, you can move the marguee selection around as a whole to fine tune your selection.
Someone finds it annoying when using Split Polygon Tool you have to press Enter and then press G to use it again. So here's the solution, when u created a split that u need, just press RMB and u will be able to create new one without exiting from the tool. Cheers.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off