Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
There is absolutely nothing fishy going on. It was a very simple reasons. As stated on the website.
one reason was to make a better branding name something that goes well with the future products. Another was Alias|Wavefront name was very long and very difficult for people outside of North America to actually pernouce the complete name. You can read the full page Here
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off