Introduction to Maya - Rendering in Arnold
This course will look at the fundamentals of rendering in Arnold. We'll go through the different light types available, cameras, shaders, Arnold's render settings and finally how to split an image into render passes (AOV's), before we then reassemble it i
# 1 31-01-2007 , 10:10 AM
Registered User
Join Date: Mar 2006
Posts: 59

Printing in 3D

hello everyone. I am looking to print off my maya model using a rapid prototyping technology company on the internet. I don't have a clue how to go about it. I am ideally looking to go for some king ofsemi transparent, hard smooth material. I think I need to convert my file to an STL file. Is this right? If so, how do I do this? Anyone got any advice on cheap companys I could use? Any advice much appreciated user added image

# 2 11-02-2007 , 09:28 PM
danotronXX's Avatar
Subscriber
Join Date: Jun 2005
Location: cleveland ohio
Posts: 313
couple summers ago I went to a university camp where we had to design a mini car model using autodesk inventor and we had a machine that made the 3d object in plastic in the end. was really cool but that was inventor so not sure about maya.
Oh and was super expensive too. my instructor told me it cost that machine about 100$/hour just to operate.

# 3 18-02-2007 , 10:58 AM
wasatch5_sparticus's Avatar
Registered User
Join Date: Feb 2007
Location: my house!!
Posts: 261
Yes, you do need to convert the file type. I don't know yet how to do it, but I do know that I'll be learning in a week or two... I'll get back to you on it!

Sparticus


Expect to excell...
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads