Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I am having problemscreating a birali surface even though my curves are all snapped to one another.
Does anyone have any ideas what else could be the problem, I have gone over my curves and pulled them away from there curves and snapped them back together but to no pravail.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off