Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 09-11-2007 , 10:43 PM
james_s's Avatar
Subscriber
Join Date: Jan 2004
Location: Connecticut
Posts: 65

MechTut_WIP

Been working on the Mech Tut as I've been having some difficulty with the proxy mesh stuff in the Apache Tut.

Not sure if I should've gone so far with the geometry. I like the look but am not sure how much detail could/should be added later via bump/displacement mapping. Not really any experience there yet.

I also changed it up a bit, swapping the "sensor", from the tut with a gatling gun just for kicks. I'm also thinking about messing with the main guns a bit -- going for a shoulder/arm assembly, rather than just hanging them off the main chassis. I don't really know what I'm doing but I'm having a good time...

Crits welcome.

Attached Images
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off