Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Ok, I have been extruding multiple edges and every single time, the edges are not together, so I ended up merging the vertices one by one. Is there a better way to merge multiple edges without merging the vertices afterwards?
Better explaination is from the pic below...
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off