Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 19-09-2003 , 07:01 AM
THX1138's Avatar
19 year Veteran
Join Date: Sep 2002
Location: U.S.A.
Posts: 2,140

Light Bulb

I did two variations on this one. The first one sucked. This second one turned out much better. The lighting was the hardest thing about it, so thats what I focused the most on.

Comments are welcome.

Attached Thumbnails
# 2 19-09-2003 , 11:07 AM
TheGreenGiant's Avatar
Subscriber
Join Date: Jul 2003
Posts: 109
hmm. the glass should be visible (have a look at a lightbulb anywhere, you should be able to make out its shape). Use the materials incandescene to bring it out a little. You should try to use an extruded surface as the light filament and the glow should be readable.

its a bit dark too and a little hard to tell what's going on. But the lighting on the bulb should illuminate the surrounds a lot more. I would lose the shiny table surface. There's a short film you can download if your connection is fast enough - there are 2 actually - its called BULB and BULB 2. Look for them if you can - I can't remember where I found them from but they'll be usefully to see CGI lighting could be done.

# 3 19-09-2003 , 10:43 PM
THX1138's Avatar
19 year Veteran
Join Date: Sep 2002
Location: U.S.A.
Posts: 2,140
Thanks for the comment, and the suggestions! I will keep working on it.

Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads