SimplyMaya Forums

Welcome to the forum, feel free to ask questions here.


SM Forums / Lounges / Maya Basics & Newbie Lounge / Getting back into Maya - some questions!

Maya Basics & Newbie Lounge Please post in this section ONLY if your question doesn't fit in anywhere else on the forum, or if you're not sure which section it's relevant to. We also have Free streaming trial available.

Join the conversation. Reply to post
 
Thread Tools
11-05-2007, 12:18 AM   #1
azimuth
Subscriber
 
Join Date: Jun 2004
Posts: 119
Getting back into Maya - some questions!
Hello all,

I havenít done any Maya work in months, but over the last week I have re-installed and realised why I enjoyed it first time round! :attn:

So, with any luck I will have some WIP shots to post soon, but first a few questions.

1) I think I know the answer to this but anyway. I converted a half complete model into SubD's to see how it looked. I then tweaked the model and made it look a lot more fluid and as I wanted. Bearing in mind I did not extrude or do any deleting only vert moves, is there a way I could have converted back to Polygons but having exactly that same face, edge and vert count?

When I tried to convert back I ended up with loads more faces, edges and verts that would have made further modelling really hard. In the end I scrapped the idea and went back to a previous save point.

2) I have been modelling a head and body separate. So far I have concentrated on the head. To get it looking nice and crisp I have increased edge numbers. When I come to adding the head to the body do I need to keep the flow of edges going, so that the body which does not need as much detail has the same large amount of edges? So far I have kept all faces 4 sided, is it a good habit to keep an entire model like this?

For example: the base of the neck on the head model has 20-30 edges, where as the connecting location at the top of the shoulder has only 10-15 edges. Should I split the body into much smaller parts to allow for a clean flow of edges from the head down to the feet? From there I could be faced with simple or small geometries needing loads of edges just to match the amounts in the head!

There will be more questions to come I'm sure as I work on further parts of the WIP, look out internet Azimuth is back in town...
  Reply with quote
11-05-2007, 03:59 AM   #2
BadG3r
Subscriber
 
BadG3r's Avatar
 
Join Date: Jan 2007
Location: Frankfurt
Posts: 216
1) go to modify->subD2poly->option box. under tesselation method you've gotta hit "vertices". this gives you the original mesh without added faces and such.

2)4sided is always better. you have to have 4sidedPs when smoothing otherwise you will get artifacts. some rendered problems can be solved overlooking the geometry and, if existing, getting rid of 5+sidedPs.

with the head. if you need to merge the meshes you should go with even faceNumbers.

if nobody will see the "seam" you don't have to merge them.
  Reply with quote
Reply

Thread Tools


Similar Threads
Thread Thread Starter Forum Replies Last Post
Issues for max to maya users bertvaneeckhout Maya Modeling 23 25-09-2014 09:36 PM
Cant open file Jimmer Maya Basics & Newbie Lounge 0 18-09-2014 03:58 AM
Rendering Problem NoxRequiem Lighting & Rendering 6 01-04-2011 09:39 AM
How do you back up your maya projects? arran Maya Basics & Newbie Lounge 14 03-01-2007 06:41 AM
Use Maya For Game... Why Maya? Triple-x Maya Basics & Newbie Lounge 14 02-09-2005 09:07 PM