Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 27-09-2013 , 12:03 AM
CyberGolem's Avatar
Registered User
Join Date: Nov 2009
Posts: 30

Bad render with Instanced Particles

Hi,
I created a snapshot sequence of an animation then referenced it in a particle system as an instance. It's all working fine with the exception of the render. I checked the snapshot sequence and those objects render fine, but when it's rendered as a particle it looks completely wrong. The 1st pic is the way it should look, the 2nd is the way it's actually rendering and the last is the shader network.
I'm also going to post this in the rendering section since it seems this problem may be relevant there as well.
Thanks much,
~CG

Attached Thumbnails
# 2 27-09-2013 , 05:03 AM
CyberGolem's Avatar
Registered User
Join Date: Nov 2009
Posts: 30

!! RESOLVED !!

Just in case anyone else ever runs into this same problem, this is how I fixed it:

--Unchecked "Enable Default Light" in the Common tab of the Render Globals.
--Applied the high quality display setting to all the snapshot reference meshes (keyboard short cut "3"). For some reason when these are in the low quality mode, the shader looks blown out. There's probably a deeper issue here that I haven't unearthed, but since this works, I'm running with it.

Back to the madness.
~CG

Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads