Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 30-11-2004 , 01:47 PM
Stephen's Avatar
Subscriber
Join Date: Sep 2002
Location: northampton
Posts: 249

Add joint to existing skins

Hi all merry xmas,
Can anyone tell me how you can add a new joint to an already skinned character?
I have forgotten to put the jaw in but have skinned all the weights taking hours. I then exported the weights added the new joint then imported the weights again but it doesnt include the new jaw joint!

cheers all
steve


It is by my will alone I set my mind in motion
# 2 01-12-2004 , 01:19 AM
Registered User
Join Date: May 2004
Posts: 24
Believe your out of luck. You can not do that unless you did an incremental save. If you did ** & should at all times ** all you would do is go back to a point in your saves & pick up a previous scene from there.

Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads