Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Hi just have a quick question about extrude face.
Whenever I select some face to extrude & keep face together
Is on. All the face split in all different direction.
Any solution to this problem. also I am not selecting some other faces. Tried it 5 times
And I did reset extrude tool's
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off