Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Can anyone help get the handles to go back to their original size. I cannot select the centre manipulator as the xyz arrow handles have retracted up tight against it.
Posting my own reply as I found the answer from esion a couple of lines below on a similar problem. I had no idea the plus and minus arrows would resize the handles. Newbie..you bet! It had me stumped and I really did read and search! Thanks.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off