Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 04-02-2003 , 12:08 AM
I-Iybrid's Avatar
Simply Maya OG
Join Date: Dec 2002
Location: Queensbury NY, US A
Posts: 1,438

Attaching NURBS surfaces

I have some surfaces lofted from some curves. I got the 1st couple of curves lofted with no problem. But when i got further down the line, the results werent pretty. Take a look.

Before Lofting:

# 2 04-02-2003 , 12:09 AM
I-Iybrid's Avatar
Simply Maya OG
Join Date: Dec 2002
Location: Queensbury NY, US A
Posts: 1,438
After Lofting:

# 3 04-02-2003 , 04:32 AM
Oculus's Avatar
Subscriber
Join Date: Oct 2002
Location: Murfreesboro, TN
Posts: 175
It probobly has somethin to do with curve direction, which affects loft direction. Try reversing curve direction. Just play around and youll figure it out. =]


- Chris L. Harkins -
# 4 04-02-2003 , 07:18 AM
undseth's Avatar
Subscriber
Join Date: Aug 2002
Posts: 1,135
Or you can reverse or swap the directions of the buggy surface, I think.


I do not support Bush! Nor Saddam! Long live UN!
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads