Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Looking back at my life, I have had alot of success with things that are in parralax with me learning 3d on my own and getting good at it. So i have alot of confidence in doing this. Thanks
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off