simple but my first finnished 3D model using maya

Maya 2020 fundamentals - modelling the real world

Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.

Watch

# 1 06-05-2004 , 03:40 PM

Registered User
Join Date: Jul 2003

Location: NJ, USA

Posts: 6

simple but my first finnished 3D model using maya

maybe not a 100% complete because I think there're some things I can fix like the texture on the side of the top part of the stapler and on the label on top there is a line right under the letters that is not suposed to be there.

please give me some C&C.

Quote

# 2 06-05-2004 , 04:48 PM

Registered User
Join Date: Aug 2003

Posts: 11

It looks nice !

Quote

# 3 06-05-2004 , 04:57 PM

Registered User
Join Date: May 2002

Location: Niagara Falls, Canada

Posts: 5,310

Really nice for you first project...... only thing i notice is some of you textures stretch but you will learn how to fix that in time..

I am enough of an artist to draw freely upon my imagination, knowledge is limited, imagination encircles the world. (Albert Einstein)

https://www.artstation.com/kurtb

Quote

# 4 07-05-2004 , 06:25 PM

Subscriber
Join Date: Jul 2002

Posts: 1,253

a little bit of bumping on the floor and some texturing work on the staples and some soft work on the walls would make it look good... never theless, nice for your first project - best of luck!!!

Quote

# 5 07-05-2004 , 08:01 PM

Registered User
Join Date: Jul 2003

Location: NJ, USA

Posts: 6

thanks for the C&C

as you can see, I fix the texturing problem. the images is still pretty simple but I was just showing the staplers. I'might add some more stuff to it. I also added images to the post so that you can see the lighting setup I used in maya.

please more C&C