Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I'm pretty new to maya and I'm not sure if I've done everything right here but it looks kinda grainy and splotchy. Any ideas on how I can make it better? Thanks!
It looks fine, I don't see the grain and splotches you're talking about. Though a better camera angle would be nice, make it less obvious its just sitting on a plane, and I think the reflections are crystal clear, could use some blurring (you're new, so not a big deal at this point so its more of a side note). Other than that, good job, and welcome to the world of Maya
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off