Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 11-08-2009 , 02:50 PM
abojung's Avatar
Registered User
Join Date: Aug 2009
Location: bangkok
Posts: 1

help with the HULL modifier in maya

i seriously need help with the hull stuff in maya. in the yamaha modeling section, part 1, where we have to start with the tyres. when i try to select the inner hull points and scale, the whole geometry of the torus starts deforming, instead of only the inner points getting deformed. is there any specific settings required for doing that or im missing something. help will be really appreciated
thank you

# 2 16-08-2009 , 10:34 PM
NextDesign's Avatar
Technical Director
Join Date: Feb 2004
Posts: 2,988
Try selecting the loop that the points are on, instead of the points themselves.

Another way around this, would be to just go to CV mode, select the loop by hand, and then scale it. Hull is just a quick way to select loops really.


Imagination is more important than knowledge.
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads