Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
It's a good start but if I were u I would use something like fur or paint effects to do the beard rather than doing it with geometry. In the long run i think that that would be easier and give you better results.
Hey guys, I chose to remodel the whole thing over... I wasn't really happy with the way the head looked nehow. I do have a bit of a problem though, because I really have no clue how to attach fur or hair to any surfaces i modelled. Whenever i select the object and choose to create fur, the whole front side of the face gets it. I need to know how to select certain areas of the face, such as the chin or sides only. So if anyone has ne suggestions or can point me in the right directions with some quick tuts or samples, I'd really appreciate it.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is Off |
HTML code is Off