Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Although there might be a way to do this, I myself am not aware of a way. Usually when I want to select vertices or CV's, I'll select them, then hit 4 to go into wireframe mode, then hold down Ctrl and drag around the vertices or CV's I don't want to select.
Shift will select stuff, Ctrl will deselect stuff. I think it is very important to get used ot using these two things.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off