I just needed some advice. I want to make a mousetrap, nothing too crazy of course, since I'm a newbie . I did a helix for the spring, and it was ok, but I couldnt manipulate(add enough coils) because when I tinkered with the various settings it went nuts! So I wound up scaling with the scale tool..
My question however is how do I make that bended wire, the U shape bends? Do I take a simple cylinder and bend it from the center and then stretch it out? I've tried the non linear>bend tool with all sorts of settings but I just get a mess and no pretty bend.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off