Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Well i dont think its hard to fix but its annoying because i cant extrude proparly with this lill problem. When i switch to faces there are small faces on the lines that divide faces if you guys know what i mean.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off