Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
This is one of the first things i have submitted in here...
It is a LEADTEK USB storage davice
I made it when i was bored. I havn't done much Non-organic modeling before but it is a start.
"If Less is more then think how much more more would be..."
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off