Maya for 3D Printing - Rapid Prototyping
In this course we're going to look at something a little different, creating technically accurate 3D printed parts.
# 1 03-07-2007 , 03:59 AM
pbman's Avatar
Subscriber
Join Date: Mar 2005
Location: London
Posts: 1,135

layered shader

hey im following a tut

on a layered shader u plug in the file then it says set its blend mode to multiply or other settings but i cant find where to change this

any ideas?

thx


Now at SMU doing BSc 3D Computer Animation so its hard to get on here
My wire render tut https://forum.simplymaya.com/showthre...threadid=20973
# 2 03-07-2007 , 04:42 AM
oldhippie_tom's Avatar
Subscriber
Join Date: Sep 2005
Location: Palm Springs, Ca
Posts: 459
I hope this helps and it was what you were looking for.

Attached Thumbnails

Challenge me and I will try. Because If I should fail, failure also has a prize (Knowledge).
# 3 03-07-2007 , 04:52 AM
pbman's Avatar
Subscriber
Join Date: Mar 2005
Location: London
Posts: 1,135
yes thx

i was looking under layered shader for it

it was under a layered texture node


Now at SMU doing BSc 3D Computer Animation so its hard to get on here
My wire render tut https://forum.simplymaya.com/showthre...threadid=20973
# 4 03-07-2007 , 05:05 AM
oldhippie_tom's Avatar
Subscriber
Join Date: Sep 2005
Location: Palm Springs, Ca
Posts: 459
Have to say it took me few minutes also!!


Challenge me and I will try. Because If I should fail, failure also has a prize (Knowledge).
# 5 03-07-2007 , 08:44 PM
gster123's Avatar
Moderator
Join Date: May 2005
Location: Manchester Uk
Posts: 6,300
Have a look into the Mix20 shader for mental ray, works similar but its much better


"No pressure, no diamonds" Thomas Carlyle
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads