Hi,
Now I see what its suppose to look like.
- I started with a poly plane (subdivision 10X10)
- I attached the dmap to the geometry
- In the plane's Attribute editor, click the second tab and select Displacement map,
then turn on "Feature Displacement".
- adjust the "Initial Sample Rate" and "Extra Sample Rate"
*WARNING: The higher the numbers the longer the render time*
Ok, I rendered a few test frames to see what it would look.
In the images I provided: Image 1 and 1a/ ISR=25,ESR=6
Image 2/ ISR=30,ESR=0
Image 3/ ISR=30,ESR=6
You can play with the ISR and ESR and render until you get the look you want.
Hope this helps,
Last edited by RockyMills_01; 17-04-2013 at 12:01 AM.