Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I was searching for some advice on how to simulate the effect of accretion on a surface.
Below are some conceptual models capturing the intent on a macro level, providing a framework (chicken wire in the images) is modeled for emitting.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off