Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Lately, I haven't been able to connect to #simplymaya and I haven't figuired out why until now. The site says "irc.simply3dword.com" (no 'l' in world) when I believe it should be "irc.simply3dworld.com". Thanks.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off