Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
ya, just select the edges you want to delete and hit the "delete" key on your keyboard. then switch to Vertice selection mode and delete any stray verts that are left over.
Car-maker.
Check out my releases for RACER.
see the WWW button
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off