Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
The problem is only happening with the control vertices on my nurbs object. When I select vertices, on my polys, the move tool works fine. BUT, when I select a control vertex, the y & x axes seem to be flipped.
Note that reflection & soft selection are turned off in the move tool settings.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off