Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 25-05-2003 , 05:20 PM
Registered User
Join Date: Oct 2002
Posts: 31

Silly question for Maya 5.0

Hi everybody,

How can I prevent the Output Window from opening on my screen anytime I launch Maya 5.0?

I know this is quite a silly/unusual question, but I would like to avoid the bore of closing this window every single time I start Maya.

It only displays the following infos:

mental ray for Maya 5
mental ray: version 3.2.2.1, 27 Feb 2003
mental ray: compiled on: Windows_NT_4.0_x86

... so it's pretty useless!

Thanks a lot,

Avoosl

P.S. Does this window appear on your desktops as well?

# 2 25-05-2003 , 10:05 PM
BabyDuck's Avatar
Subscriber
Join Date: Nov 2002
Location: USA
Posts: 1,170
it is not only a maya 5.0 issue as i have that with maya 4.5 too - even when i dont load up mr every time i start maya. it is no use to close the window - as sometimes something does write to it - and it opens back up. the easiest way to get rid of it is to minimize it. then you just pretent it does not exist. whenever you render detailed results go to the output window (if you enabled that behaviour - not sure if it is enabled by default).

hope that helps

Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads