Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
press B and left mouse button and move left or right, of double click the paing selection tool in the move rotate, scale pallate on the left (iw will be the last one as its the last tool you used, that shouyld open up the tool settings
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off