Introduction to Maya - Modeling Fundamentals Vol 2
This course will look in the fundamentals of modeling in Maya with an emphasis on creating good topology. It's aimed at people that have some modeling experience in Maya but are having trouble with complex objects.
# 1 08-04-2007 , 05:36 PM
Registered User
Join Date: Apr 2007
Posts: 1

Trimming a cylinder

Hey,
I've been wondering how to easily do this for a while.
How would you go about:
Trimming the cap of a cylinder (intersecting two objects)
Trimming the side of a cylinder (project curve on surface)
Attaching the cap and the side of the cylinder.

You can trim the cap of a cylinder with "extra transformation on caps" turned on, but you can only trim the side of a cylinder if you first delete the caps.

You can delete the caps and trim the side of the cylinder, then planar the top and trim that "cap", but then you can't attach them ("trim convert" makes planar disappear)

I can't figure out how you would do this easily. The only way I could think of doing it is to split the cylinder into 4 and boundary or square the top but that seems like a lot of work. Also when would you use boundary and when would you use square if you are making a flat surface?

Thanks
Bart

# 2 08-04-2007 , 06:43 PM
NeoStrider's Avatar
Registered User
Join Date: Jun 2004
Location: Cleveland, Ohio (USA)
Posts: 1,541
haven't tried it in practice, but after creating a nurbs cylinder, why not try and 'ungroup' them in the hypergraph, so each cap and the height are all separate objects? then you can do what you like without the complications of trying to perform the actions on a whole cylinder *shrug*


Accept no substitutions.
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads