Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I 'm trying to model a robot and when i use extrude face i seem to get to many faces .....i have attached an image if some 1 could please tell me what is wrong and any fix as i have now done this cylinder about 4 different times .
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off