Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
it's a good job modeling. my only gripe would be a personal preference, i think the knuckles are a little too abrupt (and big)... so i would shrink them down and then space out the loops a bit so the increase in mass is a bit more gradual.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off