Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I have another style in maya than showed in the videos from here, so there are different ways to get the same result...
In my layout the attribute editor is about half size of the middle screen but I would like to have the one showed below because then it is easier to follow the videos...
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off