Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I have not done a whole lot of animation but I know how to get a walk cycle going but I don't know how to make the character walk across the scene. I tried the graph editor once from a Maya 6 foundation book but did not really understand how to use it. Is there a easier way. For instance could you use a motion path to make the character walk across the scene and loop the walk cycle.
how you get your character walking across the scene depends on how you set it up. Usually you would have a control object or a group under which your character is parented.
Yes you can look cycles using the trax editor
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off