Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
So I made a primal object and inserted edge loops onto it. I was able to adjust the size of the edge loops by selecting the vertexes and then using the scale tool to move them. Then when I tried to move to the side view of the object I'd select the vertexes but when I attempted to scale inside the boxes a smaller grey box would appear and I couldn't move them.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off