Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Now and again I run into the 'can't find appropriate startup camera' error when saving. this morning, I noticed that if I went to display>show>all, and made sure isolate select was unchecked the file saved with no error.
So, I can only assume that the error is caused by some combination of the various hide/show/view commands, but I don't understand enough about Maya to be able to pinpoint what.
Can anyone shed any light about how the cameras and their settings are saved?
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off