Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
hey all! i am wanting to animate a very very very simple looking snake along a motion path! does anyone have any ideas how this can be done easily. I was hoping to avoid rigging the snake and animating each bit!............its for an animatic so im not too botherd about it look good!
look at this tutorial. there's a quick setup, but then the snake will follow your motion path pretty nicely... and it doesn't take too long to do, either.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off