Maya for 3D Printing - Rapid Prototyping
In this course we're going to look at something a little different, creating technically accurate 3D printed parts.
# 1 20-04-2004 , 10:44 AM
ransick's Avatar
Subscriber
Join Date: Feb 2004
Location: Amsterdam
Posts: 731

window_question

I saw in one of the smtuts that the attribute editorwindow was loose of where it originaly comes to stand. So that you can put the window outside/everywhere you want...

...how do I do that ?

thx allready!
user added image


...
# 2 20-04-2004 , 11:10 AM
jsprogg's Avatar
Lifetime Member
Join Date: Feb 2004
Location: Chicago
Posts: 1,712
go to window at the top and click on setting/preferences..then click preferences and make sure interface is selected, if you look to near the bottom you will see Open Atribute Editor in seperate window...check that and you are good to go user added image




2 x Modeling Challenge Winner
# 3 20-04-2004 , 11:42 AM
ransick's Avatar
Subscriber
Join Date: Feb 2004
Location: Amsterdam
Posts: 731
ok than!! thanks man! Im good to go user added image


...
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off