Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I have setup an environment image based lighting with an hdri image.
As the image shows, the whole mesh reflects as I'm using a Binn M. So far so good.
However, I would like to add a different hdri image to be reflected on the helmet shield as the green arrow points. I'm trying to make the shield to look like HALO (the game) sunset reflection.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off