Trimming a cylinder

Substance Painter

In this start to finish texturing project within Substance Painter we cover all the techniques you need to texture the robot character.

Watch

# 1 08-04-2007 , 05:36 PM

Registered User
Join Date: Apr 2007

Posts: 1

Hey,
I've been wondering how to easily do this for a while.
How would you go about:
Trimming the cap of a cylinder (intersecting two objects)
Trimming the side of a cylinder (project curve on surface)
Attaching the cap and the side of the cylinder.

You can trim the cap of a cylinder with "extra transformation on caps" turned on, but you can only trim the side of a cylinder if you first delete the caps.

You can delete the caps and trim the side of the cylinder, then planar the top and trim that "cap", but then you can't attach them ("trim convert" makes planar disappear)

I can't figure out how you would do this easily. The only way I could think of doing it is to split the cylinder into 4 and boundary or square the top but that seems like a lot of work. Also when would you use boundary and when would you use square if you are making a flat surface?

Thanks
Bart

Quote

# 2 08-04-2007 , 06:43 PM

Registered User
Join Date: Jun 2004

Location: Cleveland, Ohio (USA)

Posts: 1,541

haven't tried it in practice, but after creating a nurbs cylinder, why not try and 'ungroup' them in the hypergraph, so each cap and the height are all separate objects? then you can do what you like without the complications of trying to perform the actions on a whole cylinder *shrug*

Accept no substitutions.

Quote

Reply to this thread