Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 04-11-2005 , 01:14 AM
parka's Avatar
Registered User
Join Date: Aug 2005
Posts: 102

Unable to fullcrease for sharp edges

Below are 2 illustration for my problem.

After selecting the top and left edges of my SubD (figure 1), applying fullcrease, I can't seem to get the effect I want (figure 2).

Nothing happens.

I have a lot of other similar areas and it's a 50-50 chance that I get a sharp edge.

I can't find out what seems to be a problem.

(The figures are part of a car that I'm trying to model. )

Thanks.

user added image

user added image

# 2 04-11-2005 , 11:26 PM
Subscriber
Join Date: Oct 2005
Location: US of A
Posts: 114
Since it is a 3d model, there is also another edge that runs perpendicular to the image in this case. You may need to full crease that as well in order to get the desired effect. Without looking at the binary file, its hard to say for sure.

Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads