Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 04-11-2002 , 12:15 PM
Jim's Avatar
Registered User
Join Date: Jun 2002
Location: Adelaide Australia
Posts: 201

Trax problems fixed somewhat now (just plain ignorance)

Hi all,

Just an amendment to the earlier speel about problems related to the Trax editor and NLA in Maya.

I previously outlined why Trax was not quite useable for complex animation in an earlier post. the jist of the problem for me was that I found it hard if not impossible to adjust f curves after moving around, scaling, cycling and splitting clips. I have found a nice workaround for just these problems.

read on......

figure 1.

shows the trax editor with a couple of poses (subcharacter nodes as well). I use this to block out the timing for the animation (great for seeing followthrough and secondary actions, etc..). I often get rid of the blends between the poses and just watch the poses 'pop' between each other as the blends can be a bit distracting when trying to 'map' out the timing of an animation.


Figure 2.

shows 'merged' poses into clips (select two or more poses and then edit>merge. (notice the removal of the blends between the poses before merging). This creates only keys in the new clip from the previous poses, interperlation is by default linear or stepped. You will also notice a couple of extra keys in the new clip, I just delete them if not needed.

figure 3.

shows a clip with the keys activated and now ready to adjust either in the timeline or graph editor. I also select all the keys in a clip and make them 'flat' tangents to begin with.

This technique has allowed me to:

block out my poses
build clips (where my animation actually is f curve wise)
and begin to layer my animation in a non destructive/non linear manner with perfect access to my f curves at all times.


So yes trax works great now........

re Jim


Mayan elder......only in years.....

Last edited by Jim; 04-11-2002 at 12:25 PM.
# 2 04-11-2002 , 02:23 PM
Kurt's Avatar
Registered User
Join Date: May 2002
Location: Niagara Falls, Canada
Posts: 5,310
Glade to here its working I never really got into the trax editor, just did one simply project in school with it. I should play a round more with it. I'm more of a traditional animation guy, key frameing the whole scene =).

Kurt


I am enough of an artist to draw freely upon my imagination, knowledge is limited, imagination encircles the world. (Albert Einstein)

https://www.artstation.com/kurtb
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads