Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 10-02-2011 , 05:49 PM
Registered User
Join Date: Feb 2011
Posts: 7

Add CV using CV Curve tool

Hi guys,

I'm using the CV curve tool in Maya 10 and have missed off a couple of points and was wondering if anyone knew how to add more once the curve is finished because its taken me quite a while so far and i dont fancy starting again.

Any ideas?

Thanks
Ben

# 2 10-02-2011 , 11:47 PM
Perfecto's Avatar
Registered User
Join Date: Mar 2007
Location: TN (USA)
Posts: 1,889
Depending on exactly what you're wanting to do, you might be looking for the "Add Points Tool" under the 'Edit Curves' Menu. Just select the curve you want to add more points to, then click the Add Points Tool and you should be able to continue adding more points to the curve.


Don't be satisfied with what you can do but rather strive to do the things you can't do!
Exceed Expectations!
# 3 10-02-2011 , 11:54 PM
Perfecto's Avatar
Registered User
Join Date: Mar 2007
Location: TN (USA)
Posts: 1,889
Just in case you're not wanting to extend the curve and you just want to add more points, you can select the curve, right click and select 'Curve Point'. Then hold down the shift button while adding points. Once you've added all the points you want to add, go up to the edit curve menu and select 'Insert Knot'.


Don't be satisfied with what you can do but rather strive to do the things you can't do!
Exceed Expectations!
# 4 11-02-2011 , 05:57 AM
ctbram's Avatar
Moderator
Join Date: Jan 2004
Location: Michigan, USA
Posts: 2,998
You can also right click on the curve and select edit points. Then shift click the curve to add all the knots where you want them. Then from the edit curves menu select insert knots. Just a suggestion though after adding knots you might want to rebuild the curve as its parameterization may no longer be uniform after knot insertion.


"If I have seen further it is by standing on the shoulders of giants." Sir Isaac Newton, 1675
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads