Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
No red flags I see. Spec-wise it seems good for its price. But it's a newer model so again, there's not really any reviews/customer feedback to refer to, besides looking at older models. It'll come down to when you actually use it to see if it works well or not, if its physical design is good.
So yeah, just test it out for a bit. When you're working on 3d stuff, or any other high-performance tasks, see how its doing. See how the heat is under the laptop, if it slows down after some time, etc. Good luck, have fun lol.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off