Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
this is what i am going to try and do a "ROBOT REPAIR UINT"
its for all your robots the need a fix:p well it will look some thing like this ...now i did this in a moving car but its a start i will do a better one later sorry about the bad picture ..
Yaaa, we have our first true starter ... (unless wicket was serious). Alright, this looks like its going to come out great.. just dont try to get it over with too fast, make sure you remember detail . If you get to the point, model the inside too .
"I should call you sugar maple tree cause i'd totally tap that" haha
Wow, its looking really nice already. Can you give us a full shot of it sofar? and not just the back part? Because it looks like you have done lots since your first full image of the whole thing . Thanks.
"I should call you sugar maple tree cause i'd totally tap that" haha
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is Off |
HTML code is Off